Frequently Asked Questions - Kingsbridge Solar Wall Light

Hello,

Thank you for your question

The light can stay on continuously but it would be dimmer compared to the PIR setting /mode

Hi Hannah, our Kingsbridge is aluminium metal 

Hi Sophie, thank you for your message, the battery in the Kingsbridge cannot be replaced 

It's a frame base so you can place a plant pot to sit on the bottom. 

You have to press and hold for 3 seconds to activate the unit.

You have to press the switch button to change through the modes or switch it off completely. 

Yes, the on/off switch button is located next to the pir sensor.

The solar panel is integrated and is located on top of the unit.

The light can stay on continuously but it would be dimmer compared to the PIR setting /mode. 

You will have to press the switch button 3 times.

On mode 3 the unit will work as a security light. 

The solar panel is integrated. 

It is 40 Lumens.

This light has to be placed on a South facing wall as the solar panel is integrated.

Yes, on mode one the light will stay on continuously but it will be dimmer (like a power saving mode).

The height is 27cm and the width is16.5cm.

It is 40 Lumens. It will be able to cover this area. 

Dimensions

• Height: 27cm
• Width: 16.5cm
• Depth: 15cm

It is 40 Lumens. It can be used as a welcome light.

Dimensions

• Height: 27cm
• Width: 16.5cm
• Depth: 15cm

Height: 27cm , Width: 16.5cm , Depth: 15cm

No, this is motion only. You can choose a low light mode, but this will activate to brightness when there is movement, so would not recommend it. 

Dimensions

• Height: 27cm
• Width: 16.5cm
• Depth: 15cm

Please see the different modes below: 

Mode 2: Light is set to remain at low brightness until motion is detected which activates high brightness for up to 25 seconds
Mode 3: Light will only activate when motion is detected for up to 25 seconds [This is the best mode for winter]

Press 1: Light ON - Press and hold for three seconds
Press 2: Switch to Mode 2
Press 3: Switch to Mode 3
Press 4: Light OFF - Press and hold for three seconds

There is no way of shut off the sensor. 
 

The light is made from aluminum. 

It is black colour.

Please do push the on/off button next to the sensor. 

Yes, on mode one the light will stay on continuously but it will be dimmer (like a power saving mode).

warm white 

The diamention are:

• Height: 27cm
• Width: 16.5cm
• Depth: 15cm

These are open sided, so thr eis no glass/plastic. 

As this is motion dection light then yes, however we strongly recommend due to the integrated panel that these are placed somewhere open without obstructions (not north facing)

The panel is located at the top of the light, it is integral. 

27cm x 16.5cm x 15cm 

Please carefully consider where you wish to install your light before making alterations to your property. It’s particularly important that the solar panel receives as much sunlight as possible. Ensure that it is not obstructed by buildings, fences, trees, sheds, etc, or the shadows that these create.If the solar panel is installed in a poor location, it may not perform to the best of its ability.The Kingsbridge can be mounted onto a flat, vertical surface,such as a wall. Once you have decided on your light base location, place and mark the two holes you need in the mountingbracket. Place the light aside, drill your two marks and mount using the supplied screws and screw plugs. 

Dimensions are: 27cm x 16.5cm x 15cm