Frequently Asked Questions - Zenith Solar Wall Light

Stephen, thank you for your message. Our Zenith light is a dusk till dawn so when it starts to get dark, after the light got a full charge in the sun it will turn on and can last up to 16 hours 

Hi Nish, the IP rating for out Zenith is IP56

This would be 8cm.

The voltage should be the same, the mAh could be higher. 

The on/off button is inside the back of the light, so it would not be immediately accessable. 

We strongly recommend leaving the light switched off for 5 days to allow a good base charge on the batteries. As we are now in autumn/winter we would recommend using the power-saving mode for doubling the run time, so do check the instructions on how to activate this. Please also make sure the light is in the open and there is no heavy shading over the panel. 

No as the panel is on top. 

60 lumen

I am afraid not. The panel needs to be on top and exposed in direct daylight. 

There is an on/off switch button located at the back of the unit. 

The on/off button is on the inside of the back of the light, so not easily accessible to turn off. 

No, if there is light getting onto the panel it will not work. 

This light is waterproof.

This would be 8cm

It comes with fixings and fixtures and just screws into the wall. 

This light is warm white. 

The light is activated by the photocell, it will automatically come on when it turns dusk. 

21cm wide light,

This is automatic dusk light and dos not have a PIR option. 

We recommend to change the batteries every 2-3 years

No it cannot be plugged in the light works purely on solar power, yes the lights automaticaly come on when detecting darkness and turn off when daylight is detected. 

I have requested this from our team, we do try to provide lengths and all appropriate information. 

yes it does , at the back of the light 

21cm wide light, the light is arriving October.